Get the satisfaction that comes from knowing YOU did the job right!

Video Img  

Oil Filters

  1. Use proper protective gear. Used motor oil should not come in contact with bare skin. Engine oil may be hot.
  2. Place a drain pan under the oil filter and unscrew oil filter.
  3. Clean mounting base making sure the "O" ring from the old filter is not stuck to the filter mount.
  4. Apply film of clean oil to filter gasket. Do not use grease.
  5. Screw new filter on until gasket reaches base contact. Then tighten according to instructions on filter using tightening guide markers.
  6. Check owner's manual for correct oil specification, viscosity and amount.
  7. Add oil to "full" on dipstick. Idle engine for five minutes and check for leaks.
  8. Shut off engine and recheck oil level after 5 minutes and top off as necessary.

Video Air Img  

Air Filters

  1. Use proper protective gear.
  2. Loosen wing nut or other fasteners to remove filter cover.
  3. Remove old air filter.
  4. Clean filter cover and housing using a shop vacuum.
  5. Install new air filter. Be sure it is sealed around the perimeter.
  6. Replace cover and fasten.

Video -img -freshbreeze -NOPLAY  

Freshbreeze Cabin Air Filters

Find vehicle-specific FRAM Fresh Breeze model numbers, how-to installation videos and step-by-step instructions here.

Additional Training Videos

Oil Filter Anatomy - 2011 FRAM Challenge Video 1 Oilfilteranatomy Filtration and Engineering Testing - 2011 FRAM Challenge Video 2 Filtrationandengineeringtesting
FRAM Oil Filter change on a GM Ecotec GMEcotec FRAM Oil Filter change on a Mazda 2.3 Mazda23
FRAM Oil Filter change on a Hyundai/Kia V6 Hyundai_kiaV6